A hydrogen gas turbine burning hydrogen bought at $4/kg spends about $218 per megawatt-hour on fuel alone in a 55%-efficient combined-cycle plant, roughly 8.6 times the $25/MWh a U.S. combined-cycle plant spends on natural gas at the Energy Information Administration's 2026 Henry Hub average of $3.37/MMBtu. On fuel cost alone, hydrogen matches gas only at about $0.47/kg.
That gap is the starting point for any power producer or industrial site thinking about hydrogen-fired generation. It does not mean hydrogen turbines make no sense. It means their case rests on something other than fuel cost: a carbon price, a clean-firm-power contract, a mandate, or a niche such as long-duration backup where few hours a year are run. This guide works through the numbers a buyer needs, from fuel cost per MWh and break-even hydrogen price to the volume of hydrogen a turbine would have to contract.
This is pre-feasibility guidance for an industrial offtaker, not an engineering, procurement or investment recommendation.
What does a hydrogen gas turbine cost to run on fuel?
Fuel cost per MWh is the hydrogen price divided by the electricity each kilogram yields. A kilogram of hydrogen holds 33.3 kWh on a lower-heating-value basis, according to the U.S. Department of Energy's Alternative Fuels Data Center fuel properties table. A turbine converting that energy at 55% net efficiency produces about 18.3 kWh per kilogram, so each MWh needs about 54.6 kg. At 40% efficiency, typical of an illustrative simple-cycle peaker, each MWh needs about 75.1 kg.
For comparison, EIA's Electric Power Annual Table 8.2 gives 2025 average tested heat rates for natural-gas units of 7,535 Btu/kWh for combined cycle and 10,975 Btu/kWh for gas turbines. EIA's November 2026 Short-Term Energy Outlook, released 10 November 2026, forecasts Henry Hub at $3.37/MMBtu for 2026 and $2.88/MMBtu for 2027.
Why does hydrogen behave differently in a turbine?
Hydrogen carries a lot of energy per kilogram but little per unit of volume, so a turbine needs far more gas flow for the same heat. The DOE AFDC table gives hydrogen a lower heating value of 51,585 Btu/lb, against 20,160 Btu/lb for compressed natural gas. Per molecule, however, hydrogen is light, and that changes how blends should be read.
Treating natural gas as pure methane, our calculation from those heating values and standard molar masses shows that:
| Hydrogen share by volume | Hydrogen share of fuel energy |
|---|---|
| 5% | 1.7% |
| 30% | 12.1% |
| 50% | 24.3% |
| 100% | 100% |
So a turbine "running on 30% hydrogen" gets only about an eighth of its heat from hydrogen. That matters for offtake: the hydrogen volume a blended plant buys is much smaller than the headline percentage suggests, and so is the emissions cut from the hydrogen alone.
Manufacturers state capability by volume. GE Vernova says its turbines have run on fuels with hydrogen content "ranging from 5% (by volume) up to 100%", and that actual levels vary by turbine model and combustion system. Check the guaranteed blend, by volume and by energy, for the specific combustor you would buy.
How does a real hydrogen-capable plant start?
The best-documented U.S. example is IPP Renewed in Delta, Utah. Mitsubishi Power's project page describes an 840 MW class combined-cycle plant with two M501JAC turbines, starting at 30% hydrogen by volume with a target of 100% hydrogen by 2045. The Intermountain Power Agency says renewable power will run electrolysis and the hydrogen will be stored in underground salt caverns.
Trade press reported in January 2026 that the turbines were operating commercially and that hydrogen blending was planned to begin in the second quarter of 2026 (Turbomachinery Magazine, trade press). We could not confirm from a primary source whether blending has started, so treat the hydrogen operating date as unverified. At 30% by volume, by our blend table, hydrogen would supply about 12% of the plant's fuel energy.
Worked example: fuel cost and break-even hydrogen price
All inputs are illustrative assumptions, not quotes, project data or H2Hub outputs.
Stated assumptions:
- Hydrogen energy content: 33.3 kWh/kg, lower heating value (DOE AFDC).
- Hydrogen turbine efficiency, net, lower-heating-value basis: 55% combined cycle, 40% simple cycle.
- Natural-gas comparison: EIA 2025 tested heat rates of 7,535 Btu/kWh (combined cycle) and 10,975 Btu/kWh (gas turbine), with Henry Hub at $3.37/MMBtu (EIA 2026 forecast).
- CO2 from natural gas: 52.91 kg per MMBtu, from EIA's CO2 emissions coefficients.
- Fuel only: no capital, operations, storage, compression, NOx control or taxes.
- For the offtake sizing below: an electrolyzer using 55 kWh per kg of hydrogen and running 5,000 full-load hours a year.
Fuel cost per MWh
| Hydrogen price | Combined cycle, 55% ($/MWh) | Simple cycle, 40% ($/MWh) |
|---|---|---|
| $1/kg | 54.6 | 75.1 |
| $2/kg | 109.2 | 150.2 |
| $3/kg | 163.8 | 225.2 |
| $4/kg | 218.4 | 300.3 |
| $6/kg | 327.6 | 450.5 |
| Natural gas at $3.37/MMBtu | 25.4 | 37.0 |
Break-even hydrogen price and the carbon price that closes the gap
| Plant type | Break-even H2 at $3.37 gas | Break-even H2 at $2.88 gas | CO2 price to match gas at $2/kg H2 | CO2 price to match gas at $4/kg H2 |
|---|---|---|---|---|
| Combined cycle | $0.47/kg | $0.40/kg | $210/t | $484/t |
| Simple cycle | $0.49/kg | $0.42/kg | $195/t | $453/t |
The carbon price is the cost per tonne of CO2 that would have to be added to gas generation for hydrogen and gas to cost the same per MWh. The combined-cycle plant emits about 0.40 t CO2/MWh on gas in this example, and the simple-cycle plant about 0.58 t.
What the numbers say
- Fuel parity with U.S. gas is out of reach for now. Even hydrogen at $1/kg would leave combined-cycle fuel cost at $54.6/MWh, more than twice the gas figure.
- The carbon price needed is high but falls fast with hydrogen cost. Halving hydrogen from $4/kg to $2/kg cuts the combined-cycle carbon price needed from $484/t to $210/t.
- Few running hours shrink the annual bill, not the price per MWh. A peaker that runs a few hundred hours a year buys little fuel in total, so a high fuel cost per MWh can matter less if the plant is paid mainly for being available.
Heating-value conventions differ: we apply net efficiencies to hydrogen but use EIA's reported heat rates for gas, so treat the break-even as accurate to roughly ±10%.
Watch the ReneEnergy video: How Hydrogen Gas Turbines Work: Burning Hydrogen for Power
How much hydrogen would a turbine need to contract?
The offtake volume follows directly from the kilograms per MWh above. Two illustrative cases:
| Case | Energy per year | Hydrogen per year | Average per day | Electrolyzer at 55 kWh/kg and 5,000 full-load hours |
|---|---|---|---|---|
| 100 MW peaker, 1,000 h, 40% | 100,000 MWh | about 7,508 t | about 20.6 t | about 83 MW |
| 500 MW combined cycle, 4,000 h, 55% | 2,000,000 MWh | about 109,200 t | about 299 t | about 1,201 MW |
The averages hide the real problem: a peaker burns its fuel in bursts, while an electrolyzer on renewable power produces when the wind blows or the sun shines. Matching the two needs storage, which is why IPP Renewed pairs its turbines with salt caverns. H2Hub's Storage & Transport Lab, a subscriber tool, covers those choices.
A turbine owner buying hydrogen also faces the contract questions any offtaker does: volume, minimum take, price indexation and delivery point. The hydrogen offtake agreement checklist sets out the terms to pin down, and our guide to take-or-pay hydrogen offtake shows how committed volume changes a supplier's economics. Seasonal or peaking demand is harder to contract than steady industrial demand, so expect a supplier to price that flexibility.
For a demand-side comparison, the hydrogen truck cost per mile analysis finds a fleet can afford roughly $3–6/kg against diesel. Power generation against U.S. gas affords less than $0.50/kg, so a hydrogen producer will usually find better-paying buyers in transport or industry than in bulk power.
Try it in H2Hub
Take the supply side of this example. Start a free H2Hub project for a candidate production site sized for the 100 MW peaker case, about an 83 MW electrolyzer at 55 kWh/kg and 5,000 full-load hours, and compare the project's estimated hydrogen cost with the fuel price your turbine case can carry. Then change one number, such as the power price, and see how far the gap moves.
You can start without an account or a card. Your first full project and its PDF report are free, and downloading the PDF needs a free sign-in. Re-running with new inputs or adding a second project needs a subscription. H2Hub estimates hydrogen production economics; it does not model turbine performance, so the turbine-side numbers stay in your own calculation.
Pre-feasibility caveat
This is a fuel-only screen. It leaves out turbine capital and conversion costs, hydrogen storage and compression, NOx control, plant operations, incentives, capacity payments and taxes. Efficiencies on hydrogen and on blends must come from the turbine supplier's guarantees for your combustor. Use the result to decide whether a closer study is worth doing, not to set a price.
Frequently asked questions
Can a gas turbine run on 100% hydrogen?
Some can. GE Vernova says it has combustion technology capable of operating up to about 100% hydrogen by volume, but capability varies by turbine model and combustion system. Many existing plants are designed for partial blends, so check the guarantee for the exact unit.
Is burning hydrogen in a turbine cheaper than natural gas?
Not on fuel cost at current U.S. gas prices. In the worked example, $4/kg hydrogen costs about $218/MWh in a combined-cycle plant against about $25/MWh for gas, and hydrogen only matches gas near $0.47/kg.
What does 30% hydrogen blending mean?
It usually means 30% of the fuel by volume. Because hydrogen carries about a third of methane's energy per molecule, our calculation puts a 30% blend at about 12% of fuel energy.
Does a hydrogen gas turbine produce emissions?
Burning hydrogen produces no CO2 at the burner, but nitrogen oxides can still form and need control. Lifecycle emissions depend on how the hydrogen is produced and delivered.
Primary sources and further reading
- U.S. Energy Information Administration — Electric Power Annual, Table 8.2: Average Tested Heat Rates by Prime Mover and Energy Source, 2015–2025. Checked 19 November 2026.
- U.S. Energy Information Administration — Short-Term Energy Outlook, November 2026, released 10 November 2026. Henry Hub forecast.
- U.S. Department of Energy, Alternative Fuels Data Center — Fuel Properties Comparison. Hydrogen and natural gas heating values.
- U.S. Energy Information Administration — Carbon Dioxide Emissions Coefficients, released 18 September 2024.
- GE Vernova — Hydrogen-fueled gas turbines (company page).
- Mitsubishi Power — Aiming for clean power generation with 100% hydrogen: IPP Renewed, Utah (company page).
- Intermountain Power Agency — About IPP Renewed (official project page).
- Turbomachinery Magazine (trade press) — Utah hydrogen project links storage, gas turbines and transmission, 21 January 2026.
- ReneEnergy — How Hydrogen Gas Turbines Work: Burning Hydrogen for Power (video, 22 October 2026).
Editorial verification: 19 November 2026. Worked examples are calculations from stated assumptions, not forecasts, market prices or H2Hub-generated results.